What do you think about High Shear Mixer?

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

Ross Introduces New High Shear Mixer

Charles Ross & Son Company has announced the introduction of a new model of it's proven line of High Shear Mixers.

The PM Model incorporates a rotor/stator configuration that promotes
dual flow through a special Delta rotor/stator. This higher flow
promoted by this design is ideal for use in agglomerate reduction and
the production of fine emulsions. 

When a media mill is used to finish a product in a single pass, the PM
Model can most often eliminate the need for the mill altogether.
When the product requires multiple passes in a Media Mill, experience
has shown the PM can reduce milling time by up to 50% of that which is
normally required. Cycle times of 15 - 30 minutes are typical.

The PM Model is designed as a batch mixer and is mounted on a
conventional air/oil hydraulic lift system. Several models are
available from 5 through 200 HP.

Typical applications are found throughout the process industries and
include chemical dispersions, fine food emulsions, condiments,
cosmetics, adhesives, etc.

The primary advantages of the PM include:

  o Excellent flow and product movement of the batch.

  o Creation of a dual vortex above and below the rotor/stator.

  o Rapid incorporation of powders

  o Shortened batch times.

  o Reduction or elimination of the need for secondary equipment.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
tom Members Profile Find Members Posts Add to Buddy List Newbie Joined: 25 Aug 2007 Online Status: Offline Posts: 2	Quote Reply Topic: What do you think about High Shear Mixer? Posted: 25 Aug 2007 at 1:46pm
	Ross Introduces New High Shear Mixer Charles Ross & Son Company has announced the introduction of a new model of it's proven line of High Shear Mixers. The PM Model incorporates a rotor/stator configuration that promotes dual flow through a special Delta rotor/stator. This higher flow promoted by this design is ideal for use in agglomerate reduction and the production of fine emulsions. When a media mill is used to finish a product in a single pass, the PM Model can most often eliminate the need for the mill altogether. When the product requires multiple passes in a Media Mill, experience has shown the PM can reduce milling time by up to 50% of that which is normally required. Cycle times of 15 - 30 minutes are typical. The PM Model is designed as a batch mixer and is mounted on a conventional air/oil hydraulic lift system. Several models are available from 5 through 200 HP. Typical applications are found throughout the process industries and include chemical dispersions, fine food emulsions, condiments, cosmetics, adhesives, etc. The primary advantages of the PM include: o Excellent flow and product movement of the batch. o Creation of a dual vortex above and below the rotor/stator. o Rapid incorporation of powders o Shortened batch times. o Reduction or elimination of the need for secondary equipment.